Talk about the structural characteristics of the tensioning machine

2020-09-22

Tensioning machine is usually the fabric to maintain a certain size, in a certain temperature, humidity conditions, heating for a certain period of time and then cooling process. Therefore, the main technological conditions of thermal setting are temperature, time, tension and swelling agent. It is composed of five parts, including feeding part, weft integrator, chain, oven body and cloth rolling device. In addition has the chemical material system and the oil furnace heating system. The following molding machine manufacturers for you to explain:

拉幅定型机

1. Feeding part. The structure is relatively simple, by the material tank and roll composition, cloth into the material tank, with chemical materials, and then the roll will be the excess chemical materials pressed clean. Therefore, the cloth with very uniform chemical materials, which is the prerequisite for obtaining high quality finished cloth.


Tensioning machine


2. The weft. The pull-out setting machine is equipped with Mahlo RFMC94H type photoelectric weft integrator. Mahlo photoelectric weft integrator has four sets of sensors, each of which includes two parts, light and light. The weft Angle of the fabric can be produced by photoelectric effect. The operation part adopts hydraulic system. When the signal of weft inclination is sent back to the control board, the control board will issue instructions to drive the hydraulic system to make the bend or straight roller adjust the Angle accordingly, so as to correct the weft inclination


3. Chain part. The stretching of the cloth on the tensioning machine is produced by the chain. The chain of the setting machine is driven by a high-power motor near the cloth falling place. The chain is equipped with needle plate. When the cloth enters the chain, the brush wheel on the cloth pressing wheel presses the cloth on the needle plate on the needle, and the cloth can enter the oven under the drive of two chains.


4. Oven body. The tensioning machine has eight sets of ovens. The air is continuously sprayed onto the cloth by the fine holes in the star air jet set under the blowing action of the circulating fan. After the hot air touches the wet cloth, the temperature drops and the humidity rises, and it is discharged through the large hole in the star jet rack, passes through the filter screen, and then is recycled after heating by the heat exchanger.


5. Cloth dropping and rolling device. Resin molding machine can be used according to the production needs of push-type or roll-type cloth two out of the way. Both ways are driven by motor chain drive. When rolling cloth is used, the tension stability of cloth is required to be higher, and the cloth needs to pass through a tension regulating guide roller controlled by pneumatic. And the use of the push - down cloth, cloth without tension adjustment roller through a fixed guide roller.


The above is about the structure characteristics of the tensioning machine introduction, want to know more about the tensioning machine transformation related issues, welcome to inquire about our official website, we will explain in detail for you.



Share with