Tensioning machine is a lift-Matic pneumatic control heat insulation door plate shaping machine, can be widely used in a shuttle fabric, knitted fabrics and other textiles finishing process, a stowage molding machine equipment. Generally speaking, equipment should be placed in a well-ventilated, non-corrosive gas environment. Then the following tensioning machine manufacturer will introduce its installation process for you:

First, a stowage machine equipment. Generally speaking, the tensioning machine should be placed in a well-ventilated, non-corrosive gas environment. In addition, the storage equipment should ensure that it is flat and dry and that such a concrete root base is not less than 150 mm. Together to ensure that both sides of the needle plate are symmetrical in orientation and no errors are allowed.

Tensioning machine

Secondly, it is very important to ensure that the machine on the track is free of impurities or other obstacles to the normal operation of the chain when drawing the frame. During the transport of the roll equipment, the guide roll and the roll drop parallel to each roll required for calibration.

In this case, it is important to pay attention to the moment. Remember, no one is standing near the device. The repairman is not working. Check the room to make sure the temperature of the electronic control box is within the specified range. If dust and other debris are in the electronic control box, it should be in place at that time.

Four, when the tensioning machine presents an unexpected situation, must organize professionals to repair. The fifth part of the operation is to adopt appropriate safety protection measures, not only to ensure the normal operation of the equipment, but also to protect the personal safety of our operators.

5. Operate as required. Operators must skillfully master the operation of the tensioning machine skills and methods. And still should hold must repair technology, in the course of operation, if discover equipment to have abnormal problem, must want correct processing.

In addition, in the confirmed temperature control program, the device tension setting direction should be checked in advance of the device driver to ensure sensitive operation. The full width should be adjusted to the desired width, and the marginal shadowing and over-feed rate should be adjusted to the desired value.

The above is about the installation process of the pull-up setting machine, want to know more about the price of the pull-up setting machine related issues, welcome to inquire about our official website, we will explain in detail for you.